Positioning - Baumatic TITAN5 Instruction Manual

o The wiring in the mains lead is coloured as follows:
Brown
Blue
Green and yellow
o As the colours of the wires in the appliance's mains lead may not
correspond with the coloured markings identifying the terminals
in your spur box, please proceed as follows:
The brown wire must be connected to the terminal marked "L"
(live), or coloured red.
The blue wire must be connected to the terminal marked "N"
(neutral), or coloured black.
The green and yellow wire must be connected to the terminal
marked "E" (earth), or by the earth symbol, or coloured green
and yellow.
o When the connection is completed, no stray strands or cut wire
should be present. The cord clamp must be secured over the
outer sheath.

Positioning

o It is advisable that your appliance is only installed in a location
where the ambient temperature of the room, corresponds with
the climate classification that is stated on the rating plate of your
appliance. Your appliance may not function correctly if the
ambient temperature falls below +10°C.
Climate classification Appropriate ambient temperature
SN
N
ST
T
o Positioning the appliance requires at least two persons in order
to avoid injuries or damage to the appliance.
o Your appliance should not be located in direct sunlight or
exposed to continuous heat or extremes of temperature (e.g.
next to a radiator or boiler). If this is not feasible, then you
should install an insulation plate between the appliance and the
adjacent heat source.
Live
Neutral
Earth
+10°C to +32°C degrees centigrade
+16°C to +32°C degrees centigrade
+18°C to +38°C degrees centigrade
+18°C to +43°C degrees centigrade
37