v) Open and close door. Adjust
amount of latch / striker plate
interface by moving striker mounting
bracket towards front or back of
vehicle until door closes firmly (M in
Fig. 17). Tighten rear lower cross
brace 14mm bolts (N in Fig.17).
(NOTE: Plastic panel door frame
may require trimming on some
units.)
vi) -Optional- Transfer bracket hole
(P in Fig.17) to back panel and install
#10-32 x ¾" Lg. screw, washer and
nyloc.
vii) Install seats and ensure proper
door operation.
7. Window Operation
i) Install windows onto doors by
sliding bottom edge in first. Secure
window with (7) plastic knobs per
door.
9
Fig. 17
P
N
Fig. 18
M
L