Your DefenderCab
packing materials. Do not discard packing material until assembly is complete. Item
quantities are listed in parenthesis below.
Panels, Doors and Brackets
(1) Plastic Roof Panel
(1) Plastic Rear Panel
(1) Steel Windshield Panel
(1) Plastic Driver Side Panel
(1) Plastic Passenger Side Panel
(1) Steel Driver Door Assembly
(1)
Steel Passenger Door Assembly
(2) Polycarbonate Door Window
(1) RH Hinge Mounting Bracket
(1) LH Hinge Mounting Bracket
(1) RH Striker Mounting Bracket
(1) LH Striker Mounting Bracket
(2) Upper Panel Bracket
(4) Door Adjuster Plate
(1) Baton Strip
(1) Rubber Dust Shield
TOOLS REQUIRED FOR ASSEMBLY
Ensure that you have the following tools available before you begin the assembly of your
™
DefenderCab
kit. Note: Assembly requires an assistant.
Phillips & Flat Screwdrivers
1/4" Wrench / Socket
1/2" Wrench / Socket
7/16" Wrench / Socket
5/32" Allen Wrench
10, 14 & 19mm Wrench / Socket
3
CAB KIT CONTENTS
™
should contain the parts listed below. Separate all parts from
Hardware
(2) RH Lift Off Hinge
(2) LH Lift Off Hinge
(2) Striker Plate
(14) Plastic Knobs
(1) 25ft Roll, Hard Gasket
(1) 25ft Roll, Soft Gasket
(6 ft.) Small Edge Trim
(2) M6 x 10mm Hex Bolt
(16) ¼-20 x 5/8" Flat Head Screw
(2) #10-32 x ¾" Screw, Nyloc, Washer
(38) ¼-20 x 5/8" Screw, Nyloc,
Washer
(4) ¼-20 HEAVY Nyloc Nut
(4) ¼-20 x 3/8" Screw
(6) U-Type Speed Clip
(2) Anti-Vibration Mount
(6) #8-32 Self Tapping Screw
Electric drill
3/16" drill bit
1/4" drill bit
Utility knife
Utility Clamps or Locking Pliers
Rubber Mallet