Advertisement
v) Hold lower side panel sections
firmly against vehicle body and
pierce (3) 3/16" holes through side
panel and underside of vehicle
rocker panel. Slide U-Type speed
clips onto rocker panel and fasten
side panels with (3) #8-32 screws
each.
4. Windshield Installation
i) Temporarily install windshield
panel onto vehicle; ensure panel is
horizontal and is aligned identically
on both sides of vehicle. Use an
erasable marker to transfer bottom
edge of panel to hood surface
(Fig.8). Remove panel when done.
ii) Adhere high density foam strip to
hood using marker line as centerline
guide to ensure windshield panel will
sit squarely onto foam after
installation. Install small edge trim to
side edges of windshield and cut to
suit. Install small edge trim to lower
edge of windshield.
iii) Re-install windshield panel onto
vehicle and have an assistant hold
and press windshield panel down
onto foam strip as tightly as possible.
Line up small side edges of plastic
panels (D in Fig.9) to outer wind-
shield panel edges and transfer
holes (E in Fig.9) onto plastic panels
using 1/4" drill bit. Secure panel with
(10) ¼-20 x 5/8" Lg. screws, washers
and nyloc nuts.
6
Fig. 7
Clip onto rocker panel
Fig.8
Fig.9
E
D
Advertisement
