Advertisement
2. Rear Bracketery
i) Remove 14mm bolts from lower
mounting points on rear crossbar.
Install Striker Mounting Brackets as
shown (Fig.3). Reinstall bolts and
hand tighten only. Attach Striker
Plates using (4) ¼-20 x 3/8" screws,
keep loose for later adjustment.
ii) Remove 14mm bolts from upper
crossbar and install Upper Rear
Panel Brackets as shown (Fig.4).
Tighten 14mm bolts back into place.
(Driver side shown from vehicle
exterior)
3. Panel Installation
i) Install low density foam to interior
of panels as shown (Fig.5.) Approx.
(8) 3" long strip are required on each
side panel. Install low density foam
to entire door / panel interface.
ii) Mount side panels to roll cage and
temporarily clamp to top roll bar.
Loosely insert remaining (2) shoulder
screws to each foot well. Adjust each
panel to obtain proper alignment at
front, top and lower rear.
iii) Ensure hinge mounting bracket
edges are flush with inside door
frame and transfer hinge bolt hole
locations onto plastic panels.
Remove panels and drill holes using
¼" bit. Re-install panels and
shoulder screws onto vehicle.
iv) Mount hinges as shown (Fig.6)
with (8) ¼-20 x 5/8" Lg. Flat Head
screws. DO NOT OVER TIGHTEN.
5
Fig. 3
Interior
Fig. 4
Fig. 5
Fig.6
UP
Advertisement
