Steam Cleaning Hard Floors - Hoover Enhanced Clean Owner's Manual

2 how to Use

steAm CleAning hArd floors

WARNING
!
Never leave the Steam Mop in one spot on any
surface for an extended period of time with a
damp or wet Microfiber pad attached as this
may damage the floor surface.
Your Steam Mop should only be used on tiles,
linoleum or sealed wood flooring. If used on wax
flooring, you may experience loss of glossiness.
This steam mop may not be suitable for all
floating floorboards – please check with your
floorboard manufacturer prior to use.
To reduce the risk of personal injury, unplug the
steamer when assembling the accessories.
Do not clean over floor electrical outlets.
Do not operate Steam Mop without water in
clean water tank.
Do not use unit or press the trigger with no
water in the tank.
• IMPORTANT •
Never use the Steam Mop without the Microfiber
pad properly attached to the floor head.
■ Attach Microfiber pad. Plug in and press the
power button on the steamer (2.13).
■ The unit will take roughly 30 seconds to be
ready to produce steam. Once steam is ready to
be produced, the green "steam ready" indicator
will illuminate.
■ To recline the steamer place foot on floor head
and tilt handle (2.14).
■ To produce steam squeeze the trigger (2.15).
■ Move the Steam Mop slowly backwards and
forwards across the floor (2.16) paying particular
attention to high traffic areas.
For Disinfecting
■ Turn Clean Control dial to HIGH.
■ Follow directions for steam cleaning hard floors.
■ Run a minimum of 4 strokes at a medium pace
across same area and allow to air dry.
(continued)
2.13
!
2.15
10
2.14
2.16