Table of Contents
Advertisement
2
how to Use
Using on CArPet
WARNING
!
Do not clean over floor electrical outlets.
Do not use unit or press the trigger with no
water in the tank.
Do not fill the solution tank when using on
carpet surfaces.
• IMPORTANT •
When using on carpets, always ensure the
Microfiber pad is properly attached to the
floor head.
■ Attach Multi-Surface Microfiber Pad. Plug in and
press the power button on the steamer.
■ The unit will take roughly 30 seconds to be
ready to produce steam. Once steam is ready to
be produced, the green "steam ready" indicator
will illuminate.
■ Place the steamer into the carpet glider (2.17).
■ To recline the steamer place foot on floor head
and tilt handle (2.18).
■ To produce steam squeeze the trigger (2.19).
■ Move the Steam Mop slowly backwards and
forwards across the floor (2.20) paying particular
attention to high traffic areas.
■ It is not recommended to use solution on carpet
surface. Simply use the steam on it's own with
no solution.
After steAmer Use / Using Cooling BAse
■ After using Steam Mop and to avoid damage to
your floors, unplug and place Steam Mop in
cooling base (2.21) until product cools. Once
steamer is cooled, remove steam pad and follow
"how to clean" instructions in Microfiber pad
section on page 12 to avoid mold and mildew.
(continued)
2.17
!
2.19
11
2.18
2.20
2.21
Advertisement
Table of Contents
