ECS P6STMT2 User Manual page 29

Ecs p6stmt2 (v7.0) mainboard user’s manual
Table of Contents

Advertisement

Floppy Drive
If you have two diskette drives installed and you
enable this item, drive A becomes drive B and
Swap
drive B becomes drive A.
Floppy Drive
If you enable this item, your system will check all
floppy disk drives at start up. Disable this item
Seek
unless you are using an old 360KB drive.
PS/2 Mouse
If this item is set to Enabled, the onboard PS/2
Mouse port will work. Setting this to Disable turns
Support
off the port.
Password Check
If you have entered a password for the system,
use this item to determine if the password is
required to enter the Setup Utility (Setup) or
required both at start-up and to enter the Setup
Utility (Always).
Boot to OS/2 >
Enable this item if you are booting the OS/2
64MB
operating system and you have more than 64MB
of system memory installed.
Internal Cache
Leave this item enabled since all the processors
that can be installed on this board have internal
cache memory.
System BIOS
If you enable this item, a segment of the system
Cacheable
BIOS will be cached to main memory for faster
execution.
Spread
If you enable spread spectrum, it can significantly
Spectrum
reduce the EMI(Electro-Magnetic Interference)
generated by the system.
CAS Latency
This item determines the operation of the
SDRAM memory CAS (column address strobe).
We recommend that you leave this item at the
default value. The 2T setting requires faster
memory that specifically supports this mode.
3: BIOS Setup Utility
25

Advertisement

Table of Contents
loading

Table of Contents