Indicator
TE30 Status
Status
Blinking
Starting
green
Steady
Operating
green
properly
Blinking
Sleeping
orange
Loading the Configuration File
Using a USB Flash Drive
The TE30 automatically loads the configuration file from the USB flash drive. After the
configuration file is loaded, the TE30 can work properly.
The USB flash drive and configuration file thereon are provided by the reseller or operator. Do
not modify the configuration file. To obtain a USB flash drive, contact the local reseller or
operator.
To load the configuration file on the USB flash drive:
1. Insert the USB flash drive into the USB port in the TE30.
2. When Popup prompts, click Yes.
The TE30 automatically loads the configuration file and restarts.
If you do not perform any operations within 10 seconds after you insert a USB flash drive, the TE30
automatically loads the configuration file and restarts.
3. Remove the USB flash drive.
Using Other Methods
You can also use the methods described in the "Configuring the TE30" section in the HUAWEI
TE30 Videoconferencing Endpoint Quick Start Guide.
Indicator
Status
Steady orange
Off
Blinking red
Do not turn the TE30 or stop it from turning using your hands or other
forces when the TE30 is powered on and working properly.
6
TE30 Status
Powered off but connected to the power
supply
Disconnected from the power supply
Encountered a fault, such as a self-
check error, overheating, and software
malfunction