Table of Contents
Advertisement
Saving stations to memory
50 broadcast stations: 30 FM band and 20 AM stations can be stored to the preset memory.
During tuner mode, find a desired station.
Press MEM/PROG/P-MODE key to activate memory setting mode.
Press -10/MEM – key or +10/MEM + key to choose the desired memory location. The location number is flashing on the left side of the screen.
Press MEM/PROG/P-MODE key again to store the desired station.
Repeat steps for storing stations to other locations.
To clear the memory of any location simply save a new station to the same memory.
Selecting stored stations
Press -10/MEM – key or +10/MEM + key to choose the memory location. The stored station will be selected.
Antenna
For FM reception, adjust the telescopic antenna appropriately to obtain the best reception on the band selected.
The AM signals are picked up through the built-in ferrite antenna. The set should be placed to a position for the best reception.
FM and FM stereo reception
In particular when stereo signal is weak and much noise are received, it is preferable to receive the program in mono. Press FOLDER/FM-MODE button
to switch between FM stereo and mono modes.
Compact disc operation
Insertion and removal of discs
When opening the CD-door, always ensure the disc is not in motion (not spinning) when you open the CD-door. Always press "STOP" button to stop the
disc spinning first.
Place a CD into the compartment with the label-side (printed side of disc) facing upwards. Press down in the center part of disc until the disc "locks" onto
the center spindle.
When the CD has been placed onto the center spindle, gently lower the CD-door downwards until it locks shut.
The CD is now ready to be played.
To remove a disc, follow the same procedure as described above, except to remove the CD instead of inserting it into the compartment, by placing one
finger at the middle of disc (center spindle) & the other at the edge of the disc & gently pulling upwards.
Important :
Always hold a CD by its edges. Avoid getting any finger prints, smudges or dirt onto the surface of a disc. In case this happens, use a special CD-cleaning
cloth or cleaning kit to remove the dirt or smudges.
Important: Please make sure to always fold down the handle before opening the CD door.
Press ON/OFF key once to switch on the system power.
5
Advertisement
Table of Contents
