Wiring - Jensen DVDB01 Installation And Operation Manual

DVDB01

WIRING

Power/Accessory Connections
1
6
WIRED REMOTE
P.A.
1.
REMOTE CONTROL EXTENDER
2.
likely to use the remote control. Point remote at eye to control the unit.
CONSTANT POWER WIRE
3.
power wire to a live 12 volt wire in the vehicle. Before making a
connection, check that the wire you intend to connect it to is always live,
even when the car's ignition is turned off. If a live wire is not found, route
the wire to the car's fuse block and connect it to a live circuit there.
ACC POWER WIRE
4.
when the ignition is on. The best connection point is at the car's fuse block
at the "RADIO" or "ACCESSORY" identified terminals.
GROUND WIRE
5.
metal part of the car's chassis. If you cannot find an existing bolt or screw
to fasten it to, drill a hole in the metal and secure it with a screw. To
ensure a good ground, remove any paint or grease from areas where the
wire will contact the surface.
DC12V OUT
6.
7. Connect optional wired remote control.
IR REMOTE CONTROL EXTENDER EYE
POWER WIRING HARNESS
7
– Connect to PADIN5.
– Position extender where you are
(yellow) – Connect the 12V PLUS constant
(red) – Connect to a +12 volt circuit that is only live
(black) – Securely fasten the Ground wire to a grounded
– Provides 12VDC at 300mA when DVD is on.
3A FUSE
YELLOW
BLACK
1A FUSE
RED
7
2
+
3
4
5