Preparation - Jensen DVDB01 Installation And Operation Manual

PREPARATION

It's a good idea to read all of the instructions before beginning the installation. We recommend
having your JENSEN DVDB01 installed by a reputable installation shop.
Tools and Supplies
You will need these tools and supplies to install your DVDB01:
• Torx type, flat-head and Philips screwdrivers
• Wire cutters and strippers
• Tools to remove existing radio (screwdriver, socket wrench set or other tools)
• Electrical tape
• Crimping tool
• Volt meter/test light
• Crimp connections
• 18 gauge wire for power connections
• 16 – 18 gauge speaker wire
Disconnecting the Battery
To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable
prior to installation.
NOTE: If the DVDB01 is to be installed in a vehicle equipped with an on-board drive or
navigation computer, do not disconnect the battery cable. If the cable is disconnected, the
computer memory may be lost. Under these conditions, use extra caution during
installation to avoid causing a short circuit.
4
DVDB01