Basic Operation - Jensen DVDB01 Installation And Operation Manual

DVDB01

BASIC OPERATION

Turning the Unit On/Off
Press the POWER button (1) on the front panel or remote control to turn the unit on/off.
Inserting a Disc
Insert a disc, label side up, into the disc slot (12). The player will start playback automatically.
Ejecting a Disc
Press the EJECT button (3) to eject the disc from the slot. The unit does not have to be on to eject
a disc.
NOTE: Do not drive with an ejected disc in the slot.
Audio Control
Volume
Press the VOL /\ button (8) to increase the volume, or the VOL \/ button (9) to decrease the
volume.
Mute
Press the MUTE button (6) to silence the audio. Press MUTE again to resume audio.
Press the SEL button (10) on the front panel or remote control to select the desired audio
adjustment mode. The adjustment mode will change in the following order:
Bass Press SEL until "BAS" appears in
the display.
Treble Press SEL until "TRE" appears in
the display.
Balance Press SEL until "BAL" appears in
the display.
Clock Display
Press the T/F button (21) to alternate between playing time and clock time.
Setting the Clock
Press and hold the T/F button (21) on the remote until the clock display flashes, and then release.
Next, press < (29) or |<< (7) to adjust the hour and > (29) or >>| (4) to adjust the minutes. Continue
changing the hour to move between AM and PM.
Mode
Press the MODE button (11) on the front panel or remote control to switch between disc (DVD/
VCD/CD/MP3) mode, AV IN1, or AV IN2 mode.
Press the volume buttons to adjust the Bass from +06 to -06.
Press the volume buttons to adjust the Treble from +06 to -06.
Press the volume buttons to adjust the Balance from 12L to
12R.
Equalization
Press the EQ button (33) on the remote control to activate the equalization function. Continue
pressing the EQ button to choose between the three equalizer modes (CLASSIC, POP and
ROCK) or to turn the equalizer function off (DSP OFF).
Reset
The RESET button (16) is located on the front of the unit. You should engage the RESET button
only in the following situations:
• After initial installation when all wiring is complete
• If all function buttons become inoperable
• If an error symbol appears on the display
To reset the unit, use a ballpoint pen or a thin metal object to depress the RESET button.
AV In Operation
You can connect another audio/video system to the unit through the AV IN terminals on the back
(AV1 INPUT) or front panel (AV2 INPUT) of the unit. Once the device is connected, press the
MODE button (11) on the front panel or remote control to select "AV IN1" or "AV IN2" mode.
11