Advertisement
5.
Push the battery pack down, angle it towards the back of the
charger, and release. Refer to Figure 7. The battery pack sits
securely if inserted correctly.
Figure 7. Charging the Battery Pack without the Detector (Side)
The charger emits one beep and the LED lights red.
6.
Allow the battery to fully charge (approximately 3.5 hours).
The charging LED changes to green when charging is complete.
When the battery pack is removed from the charger, the LED
deactivates.
a Warning
When replacing battery packs, ensure the GasAlertMicro 5 IR battery
pack is only inserted into the GasAlertMicro 5 IR detector. The IR
battery packs are not compatible with other Micro 5 models and
vice versa. Refer to the IR warning label located on the back of the
IR battery pack lid.
Troubleshooting
If a problem occurs, refer to the following solutions. If the problem persists,
contact
BW Technologies by
Honeywell.
Table 3. Troubleshooting Guide
Problem
Possible Cause
The charge
The detector is not
LED does not
inserted correctly in the
activate when
cradle.
the detector is
The battery pack is
inserted.
above or below the
operating temperature.
The battery pack is
severely depleted.
Damaged or defective
battery pack.
There is no
Internal damage to
audible beep.
battery or charger.
There is an
The battery is above or
audible beep,
below the operating
but no charge.
temperature.
The battery pack is
severely depleted.
Damaged or defective
battery pack.
Maintenance
To maintain the charger in good operating condition, perform the following
basic maintenance as required.
Solution
Firmly insert the detector
•
Clean the exterior with a soft, damp cloth. Do not use solvents, soaps,
into the cradle.
or polishes.
•
Do not immerse the charger in liquids.
Allow the battery pack time
to adjust to the specified
Battery Pack Storage
operating temperature
(approximately 1 hour).
When stored for extended periods of time, ensure that the battery pack is
fully charged and then recharged every 30 days.
Contact
BW Technologies
by Honeywell
Replacement Parts and Accessories
Contact
BW Technologies
by
Honeywell.
Contact
BW Technologies
To avoid personal injury or damage to the charger, use only
by
Honeywell.
the specified replacement parts.
Leave the battery in the
charger. When the battery
returns to room
temperature, charging will
begin.
Model No.
Contact
BW Technologies
by
Honeywell.
M5-BAT01
Contact
BW Technologies
M5IR-BAT04
by
Honeywell.
M5-C01-BAT01
M5IR-C01-BAT04*
Add suffix (-UK) for United Kingdom mains plug, (-EU) for European mains
*
plug, (-AU) for Australian mains plug.
a Warning
No user-serviceable parts inside.
a Warning
Table 4. Replacement Parts and Accessories
Description
GasAlertMicro 5 and GasAlertMicro 5
PID rechargeable battery pack
GasAlertMicro 5 IR rechargeable
battery pack
GasAlertMicro 5 and GasAlertMicro 5
*
& PID cradle charger / battery pack kit
GasAlertMicro 5 IR cradle charger /
battery pack kit
Qty
1
1
1
1
Advertisement
