Do you have a question about the BMR101 and is the answer not in the manual?
Questions and answers
Barrie Earl
March 31, 2025
BMR101 stuck on welcome screen when turned on and buttons don’t respond ? Can you help please
1 comments:
Mr. Anderson
March 31, 2025
The Makita BMR101 being stuck on the welcome screen and not responding to buttons is likely due to an internal fault, such as a hardware failure or a software issue. This can happen if the radio has been exposed to physical damage, moisture, or a power surge.
2. Use the battery operated radio only with specially • Water resistant to JIS 4 designated battery packs. Use of any other battery Powered by both Makita battery pack and supplied power packs may create a risk of fire. adaptor.
Battery Installation Controls: 1. Power button 1. Pull out the battery compartment 2. Band button 3. Advanced setting button locker to release the battery 4. Info button compartment. 5. Preset buttons 6. Auto tune button 2. Insert the battery pack to power radio. 7.
Page 5
3-1. Installing or removing the Slide 4. To remove the battery cartridge, battery cartridge withdraw it from the Job site radio while pressing the buttons on both 1. Button 2. Battery cartridge sides of the cartridge. Return the 3. Red part battery compartment locker in position to close.
Operating the radio to assist the positioning of the antenna or the radio so as to optimize reception for a specific channel or frequency. This radio equips with three tuning methods - Scan tuning, 1. Press the Advanced setting button and rotate the Manual tuning and Memory presets recall.
Storing stations in preset memories (DAB 2. Select the desired waveband by pressing the Band button. Make sure the soft bended rod antenna has and FM) been well placed for best FM reception. Try to avoid There are five memory presets for each waveband. operating the radio next to a computer screen and 1.
Input terminal 3.5 mm dia. (AUX IN1/AUX IN2) Antenna system DAB/FM: soft bended rod antenna Dimensions (W x H x D) in mm 263 x 305 x 166 Weight 4.2 kg (without battery) Makita Corporation Anjo, Aichi, Japan www.makita.com BMR101-ENEU-0910...
Need help?
Do you have a question about the BMR101 and is the answer not in the manual?
Questions and answers
BMR101 stuck on welcome screen when turned on and buttons don’t respond ? Can you help please
The Makita BMR101 being stuck on the welcome screen and not responding to buttons is likely due to an internal fault, such as a hardware failure or a software issue. This can happen if the radio has been exposed to physical damage, moisture, or a power surge.
This answer is automatically generated