Download
Share
Print this page
Jensen VM9224BT Installation Manual
  1. Manuals
  2. Brands
  3. Jensen Manuals
  4. Car Video System
  5. VM9224BT
  6. Installation manual

Jensen VM9224BT Installation Manual

Jensen car video system user manual
Hide thumbs Also See for VM9224BT:
1
2
3
4

Advertisement

Quick Links

VM9224BT
EJECT
MUTE
A/V INPUT
VM9224BT
What's in the Box
VM9224BT Head Unit
Left and Right Double DIN
Mounting Brackets
Double DIN Half Sleeve Install Bracket
External Microphone
Two Custom Cosmetic Trim Rings
Parking Brake Wire
Hardware Bag
Speaker Output Harness
Power Input Harness
2 x Accessory Harness
Installation Guide
WARNING! Never install this unit where operation and viewing could interfere with
safe driving conditions.

Tools and Supplies

You will need these tools and supplies to
install your VM9224BT:
•
Torx type, fl at-head and Philips
screwdrivers
•
Wire cutters and strippers
•
Tools to remove existing radio (screw
driver, socket wrench set or other tools)
•
Electrical tape
•
Crimping tool
•
Volt meter/test light
•
Crimp connections
•
18 gauge wire for power connections
•
16 – 18 gauge speaker wire
1
Installation Guide

Advertisement

loading

Related Manuals for Jensen VM9224BT

Summary of Contents for Jensen VM9224BT

  • Page 1: Tools And Supplies

    VM9224BT EJECT MUTE A/V INPUT VM9224BT What’s in the Box VM9224BT Head Unit Left and Right Double DIN Mounting Brackets Double DIN Half Sleeve Install Bracket External Microphone Two Custom Cosmetic Trim Rings Parking Brake Wire Hardware Bag Speaker Output Harness...

  • Page 2: Optional Equipment

    To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to in- stallation. NOTE: If the VM9224BT is to be installed in a car equipped with an on-board drive or navigation computer, do not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution during installation to avoid causing a short circuit.

  • Page 3: Installation Using Half-Sleeve

    Installation Using Half-Sleeve Install half-sleeve in the dashboard. Install adapter if necessary (optional). Install half-sleeve into adapter or dashboard (use only the supplied screws). Do not force the sleeve into the opening or cause it to bend or bow. WARNING! Only connect the unit to a 12-volt power supply with proper grounding.

  • Page 4: Wiring Diagram

    Wiring Diagram IMPORTANT: Incorrect wiring connections can damage the unit. Follow the wiring instructions carefully, or have the installation handled by an experienced technician. Need Help? For technical assistance, call the Jensen customer support line at 1-800-323-4815. FRONT L FRONT R...