Wiring - Jensen VM8013 Installation And Operation Manual

VM8013

WIRING

Compatible SAT Tuners:
1. XMD1000 (requires XMC or
XMDJEN100 Cable Kit)
2. CNP2000UC
3. SC-C1 and SIRJEN2
NOTE: The amplifier in this radio is only designed for use with four
speakers. Never combine (bridge) outputs for use with two speakers.
Never ground negative speaker leads to chassis ground. Failure to
wire exactly as shown may cause electrical damage to the radio.
SAT BUS
Battery
-
Connect the yellow wire to the battery
or 12 volt power source that is always
live. This wire MUST be connected
for the radio to work.
Yellow
Chassis Ground
Connect the black wire to the factory ground wire. If a
factory ground wire is not provided, locate a clean,
unpainted metal part of the dash and secure the ground
wire with a "ring" terminal and a sheet metal screw.
NOTE: Video playback not supported for all
iPod
(Sold Separately) iPods. See iPod section for more information.
White/Black
Stripe
Left Speaker
(Front)
SAT R (Red)
SAT L (White)
Fuse (15A)
Antenna
FILTER
BOX Power Antenna
Black
Connect to power antenna or amplifier.
If not used, tape bare end of wire.
Accessory/Ignition
Connect to existing radio wire
or radio fuse.
FRONT REAR
Gray/Black
Green/Black
White
Gray
Stripe
Stripe
Right Speaker Left Speaker
(Front)
NOTE: Only connect speakers with a nominal impedance of 4 ohms.
Speakers with a load impedance less than 4 ohms could damage the
unit.
3
(Blue)
Subwoofer Out
Parking/Active Low Level Input (Pink)
Camera In
(Yellow)
Video Out 1
(Yellow)
Video Out 2
(Yellow)
Camera/Active High Level Input (Green/White)
SWC (Steering Wheel Control)
(Requires PAC SWI-PS Interface Adapter)
Rear Line out R (Red)
L (White)
Gray
Front Line out R (Red)
L (White)
Black
Blue
Red IMPORTANT!
The pink parking
wire MUST be
Purple
Purple/Black
Green
connected to the
Stripe
switched side of the
parking break
circuit (the part that
becomes grounded
when the brake is
Right Speaker
(Rear) (Rear)
+
applied).