Operation - Jensen VM8013 Installation And Operation Manual

VM8013

OPERATION

Power
Press the (power) button (1) to turn the unit on. Press and hold the power
button again to turn the unit off.
1
CH/
DISP
CAT
DIM
SRC PTY
BAND
iPod Menu
NOTE: LCD panels may take longer to respond when subjected to cold
temperatures for an extended period of time. In addition, the visibility
of the numbers on the LCD may decrease slightly. The LCD display
will return to normal when the temperature increases to a normal
range.
Source
Press the SRC button (6) repeatedly to scan the various sources. A source
is only displayed when accessible (optional equipment required for some
sources). Available modes include Radio (FM1, FM2, FM3, AM1, AM2),
SAT, DISC, SD, USB, and auxiliary (AUX IN).
External Devices
External peripheral devices, including a game console, camcorder,
navigation unit, iPod, Zune, etc. can be connected to the AUX IN connector
(18) on the front of this unit using the 3.5mm A/V Media Cable (included).
Select "SOURCE >> AUX IN" to access auxiliary devices. You cannot
directly control external devices connected to the AUX IN input.
Audio Mute
Press the (power) button (1) to silence the audio volume. "
on the display. Press (power) again to restore volume to the previous
setting.
Volume Control
To increase the volume, turn the VOL/SEL/MENU (rotary encoder) (2)
clockwise. To decrease the volume, turn the rotary encoder counter-
clockwise. When volume is adjusted, the volume level will be shown on the
display panel as a number ranging from "0" (lowest) to "40" (highest).
SWC Interface (Optional)
The VM8013 is compatible with PAC (Pacific Accessory Corporation)
INT
1 2
adapter SWI-PS steering wheel control interface. A 3.5mm female
RPT RDM
connector (labeled SWC Interface) on the back of the head unit is used to
3
4
DN UP
connect to the SWI-PS adapter. When the SWI-PS is installed, the following
5 6
functions are available:
18
A/V IN
1. Vol +
2. Vol -
3. Mute
4. Seek +
5. Seek -
6. SRC (Source)
7. Band
Audio Menu
Press the VOL/SEL/MENU button (2) to access the audio menu. Press the
VOL/SEL/MENU button repeatedly to move through the list of menu
options.
NOTE: Audio settings only apply to the current source (Source Tone
Memory). You must make audio adjustments for another source when that
source is active.
• Sub_w: When the Low Pass Filter is activated (see "Menu Operation"
on page 8), you can use the VOL/SEL/MENU rotary encoder to adjust
the subwoofer volume from "-14" to "0".
• BASS: Turn the VOL/SEL/MENU rotary encoder (2) to adjust the bass
level from "+7" to "-7".
• TREBLE: Turn the VOL/SEL/MENU rotary encoder to adjust the treble
level from "+7" to "-7".
• BALANCE: Turn the VOL/SEL/MENU rotary encoder to adjust the
balance from "R7" (full right) to "L7" (full left).
" appears
• FADER: Turn the VOL/SEL/MENU rotary encoder to adjust the fader
from "F7" (full front) to "R7" (full rear).
7