Section Viii - Internal Wiring; General Requirements; Internal Control Wiring Diagrams - Delta Performance PG-25 Installation And Maintenance Manual

Internal Wiring

SECTION VIII - Internal Wiring

WARNING
ELECTRICAL SHOCK HAZARD. For
your safety, disconnect electrical power
supply to the unit before servicing or
making any electrical connections to
avoid possible electric shock hazard.
Failure to do so can cause severe person-
al injury or death.
NOTICE
All electrical contacts shown in Figures
30 & 31 pages 43 & 44 do not have elec-
trical power applied.
shelf" condition.
Blower
Molex Plug
Fig. 29 : Burner Control Wiring
Shown as "off-
ELECTRONIC
CONTROLS
1016-400 SERIES
1
L IND LED MV PS
LED
Indicator
Air Switch
Terminals
Black
Gas Valve Plug
N L1
Snap-Set

General Requirements

- Wiring must be N.E.C Class 1.
- If original wiring installed in the unit
must be replaced, use only type T, 90ºC
wire or equivalent.
- The PERFORMANCE must be electri-
cally grounded as required by National
Electrical Code ANSI/NFPA 70 - latest
edition.
ANSI Z 21 . 20
DIRECT SPARK IGNITOR
HV
2 PS 1 W FS R X C/COM
Red
Snap-Set
Black Gas Valve Plug
T1
Red Snap-Set T2
42