Korg POLY-800 Owner's Manual page 37

Rewind the tape to a little before the recording starts, and
play it back.
Stop the tape (or press Pause) when you hear the begin-
l
ning of the leader tone.
Set the recorder Volume control to a medium level
3.
(around 5). If tone controls are provided rfeble andlot
Bass). set them flat.
Set rear panel TAPE ENABLE/DISABLE switch to the
4.
ENABLE position. The DISPLAY will show the following
message:
E N A B L E / D I S A B L E 'I" LO
5.
following:
6.
7.
TAPE
Start tape recorder playback. It will take about 14 seconds
to Verify the data. There are three possibilities:
.
The recorded data is GOOD (90 to step 7).
There is an ERROR, and either the recorded data
2.
is bad or there is a level setting problem (90 to step 6).
There is no apparent change (go to step 9).
3.
If the VERIFY operation was successful. the DISPLAY
will show (his message:
. Stop the tape recorder, and return the rear panel TAPE
ENABLE switch to the DISABLE position.
ENABLE/DISABLE 'lo
8. If you got an Err (Error) indicalion. press the CANCEL
button. You will obtain the normal TAPE message on the
DISPLAY.
TAPE INTERFACE