Korg POLY-800 Owner's Manual page 38

*Repeat the VERIFY procedure using different tape
recorder Volume settings (112 to 1 number at a time).
TAPE "HIGH/LOW" switch.
LOW/HIGH
future re1erence.
9. If the "Verty" message is still displayed 15 seconds after
starting playback. either the recorder level is loo low or
there is a problem with the cables.
somewhat higher, and repeat the VERIFY procedure
UPORTANT NOTES
YOU WILL NOT GET A "GOOD" MESSAGE IF THE TAPE
DATA IS DIFFERENT IN ANY WAY FROM,THE DATA IN
THE POLY-800, even if VERIFY has been performed pro-
perly and all setrings are fine. This is because the VERIFY
procedure checks to make sure that the Prqgram and Se-
quencer data on
THINGS TO TRY if you repeat the VER\FY procedure
several times and still do not get a "GC@" indication:
the SAVE procedure using diffejent recording
levels. When you find a level lhat works. WRITE IT
DOWN FOR FUTURE REFERENCE.
different. higher quality brand of tape.
make sure
and demagnetized.
ENABL
Both Program and Sequencer data is always recorded on the
tape. However, you can choose the data you want to LOAD
back into the Poly-800:
Program Data only
l
. Sequencer Dam only
NOTE:
LOADING doro from tape ERASES the corresponding dalo
previously in /he Pa/y-800.
Connect Poly-800 rear panel FROM TAPE jack to the tape
1.
recorder outpul jack (EARPHONE or LINE OUT). Set
FROM TAPE switch to HIGH (earphone) or LOW (line
LOW/HIGH
TAPE RECOROER OUTPUT JACK
Line oul ( AUX
Earphone
2. Rewind the tape to a little belore the recording starts, and
play it back.
beginning o! the leader tone.
3. Select proper settings for the tape recorder Volume and
Tone controls and the rear panel FROM TAPE HIGH/LOW
switch. (Use settings that produced a "Good" indication
during VERIFY)
4. Sel rear panel TAPE ENABLE/DISABLE switch to the
ENABLE position.
HIGH/LOW
LOW