Korg POLY-800 Owner's Manual page 24

2.
Parameter has now been selected.
NOTE:
If you enrer numbers rhaf ore no, in'fhe Pammerer 7bble
but Ihe VALUE section Of the Display will be blank. This
will also happen if you Iry lo access DC0 2 or DEG 2
parameters in WHOLE Mode (they are only available in
DOUBLE Mode).
Edlt the Parameter
The UP and DOWN switches in Ihe Value section are used
value of Ihe parameter is shown in Ihe VALUE section of Ihe
Display:
Press the UP button to INCREASE the value: press the
DOWN button to DECREASE the value. If you press and
release either of these buttons quickly, Ihe value will change
one step at a time. If you keep either button depressed, the
value will increase or decrease rapidly after a shorl pause.
If rhe VCF Cutoff Voluc is reduced IO near L:, rhe volume
of
When you select a Parameler and then change il. a small LED
dot will turn on in the lower right corner of Ihe VALUE Display:
The VCF Cutoff
VALUE
This dot shorn that the parameter Value has been changed;
if you restore the parameter lo its previous Value. the dot will
go out. However, if you leave Ihe new value in place (LED
first (altered) parameter - the LED dot will NOT turn on.
The LED dot only shorn when a Parameter has been chang-
ed since you selected it. It DOESN'T tell you whether or not
the Parameter Value is Ihe same as in the original ("perma-
nent") program being edited.
3 and 4 for the next parameler, and so on. Continue editing
parameters @e-editing if necessary) until the desired sound
is achieved.
press the PROGlPARA switch lo selecl
original Program Number.
To make the edited version PERMANENT, you must wile
it into memory (see Section 4.3 below).
4.2.6 Using the BANK HOLD Feature
The BANK HOLD feature allows the current Parameter Bank
number (lefl hand digit of the Parameter Display) lo be "held':
This enables you to select any of Ihe Parameters in lhat bank
with a single press of a button. for easy editing of a particular
EXAMPLE: Editing the VCF Parameters
Select any VCF Parameter (such as Cutoff. '-!
l
The Display will show the following:
your satisfaction. repeat steps
Program Mode, and