Korg POLY-800 Owner's Manual page 25

You may now select any of the VCF parameters by press-
ing one of the Number buttons. For exadple. press ' 3 '
You may also press ' 8 ' to select the Chorus ON/OFF
Parameter. (Pressing
Display.)
BANK HOLD again to cancel the Bank Hold fun0
To make any edited or newly created sound PERMANENT,
you must write it into one of the 64 Program Numbers in the
The memorlred programs are protected by the balterles.
and will not be erased when the power swllch I.? turned
off. (See the MEMORY BACKUP section, P.5. for lurther
information).
NOTE:
MEMORY WRITE PROCEDURE
Set the Program Write switch on the rear panel to the
ENABLE oosition.
~ - W R I T E - - - -
SEQUENCER
ENABLE/DISABLE ENABLE/DISABLE
2.
Make a mental note of the current Program Number, il
you want to write an edited version "over" the original
program.
select EG ;NT, and so on.
result in a blank VALUE
PROGRAM
3. Press the red WRITE button. The Program Number in
the Display will be replaced by a pair of flashing lines.
to show that you are in Wrile mode.
Press the Number buttons toselect the Program Number
where you want to store the edited sound.
EXAMPLE:
To store the edlted sound In Program Number
then '7. Afler button
DISPLAY will show the following:
NOTE:
Al fhispoinf (before rhesecond burron ispi-ascd), the "old"
round in memory is aill unchanged. ljyoupm~ed lhe wrong
THE WRONG PROGRAM):
switch the rear panel Program Write switch to the
l
switch it back to the ENABLE position
l
. press the red WRITE bution again
then press the correct Number buttons (' 3
l
The edited sound is now stored in Program Number j"-:
pressed, the
and then