Dip Switches - CompuSTAR CM4200DX Install Manual

trunk release.)
Pin 3 Orange/Black - 2
negative pulse output for driver's priority door lock. (Note: This feature will require additional relays and
programming.)
Pin 4 Blue - Unlock 250mA (-) negative output. This wire will provide a (-) negative pulse output during unlock and
disarm. (Note: Positive and reverse polarity will require additional relays.)
Pin 5 Blue/Black - Lock 250mA (-) negative output. This wire will provide a (-) negative pulse output during lock
and arm. (Note: Positive and reverse polarity will require additional relays.)
Pin 6 Not used
C 5 (CN5) (Pre-wired L.E.D.)
ONNECTOR
Pin 1 Black - L.E.D.- (-) negative output.
Pin 2 Black/White-3-volt L.E.D. (+) positive output.
C 8 (CN8) (Pre-wired Antenna Cable)
ONNECTOR
Pin 1 Yellow - RX input. This wire receives signal from remote.
Pin 2 White - TX output. This wire transmits signal to remote.
Pin 3 Red - 12-volt constant (+) positive input.
Pin 4 Black - (-) negative ground input.
C 9 (CN9) (Pre-wired Valet/Programming Switch)
ONNECTOR
Pin 1 Gray - (-) Negative valet switch input.
Pin 2 Gray - (+) Positive L.E.D. output.
Pin 3 Gray/Black - L.E.D. (-) negative ground input.
C 11 (CN11) (Pre-wired Thermistor)
ONNECTOR
This connector is for the new Thermistor which monitors temperature in the vehicle.
Pin 1 Thermistor
Pin 2 Thermistor
C 12 (CN12) (RS 232 Port)
ONNECTOR
This connector will be used for updating the module and connection to various remote start bypass modules. If you are
unsure which version of the Control Module you have then you should reflash with the most current available. The next
section details this new procedure.
________________________________________________________________________________________________
D S
IP WITCHES
The dip switches on this control module are new for the Pro Series.
Switch 1 sets the polarity of input for the red/white door trigger wire on CN3, Pin 8. In the default position switch 1
should be up and set for negative (-) Door Trigger input.
nd
Unlock 250mA (-) negative output. This wire is an optional output that will provide a (-)
6