CompuSTAR CM4200DX Install Manual page 19

4) Option 2-8 (Temp 32°F) on setting 4
5) Set the reservation time at 7 AM (see User's guide)
6) Turn on Timer Mode on the 2-Way remote. (See Remote User's Guide)
2-7 Remote Start Runtime
This option sets how long the vehicle will remote start and run for. Default setting 1 is 15 minutes. Setting 2 is 25
minutes. Setting 3 is 45 minutes and Setting 4 is 3 minutes.
2-8 Temperature of Cold Starting
This option sets the temperature at which the vehicle will remote start when setting 2-5 and 2-6 are set. Setting 2 is
-20°C/-4°F. Setting 3 is -15°C/5°F. Setting 4 is -10°C/14°F
2-9 Temperature of Hot Starting
This option sets the temperature at which the vehicle will remote start when setting 2-5 and 2-6 are set. Setting 2 is
30°C/86°F. Setting 3 is 35°C/95°F. Setting 4 is 40°C/104°F.
2-10 Setting Tach/Alternator/Voltage Sensing
There are three engine sensing modes the CompuStar can monitor for remote start. Please see the above Tach,
Alternator or Voltage Sensing sections above for more details.
1. Default setting - Tachometer Wire Sensing
2. Setting 2 - Alternator Wire Sensing
This mode requires a soldered connection to a wire on the alternator.
3. Setting 3 - Voltage Sensing – No Wire Connection, Automatic Transmissions Only.
This mode reads the vehicle battery voltage through the main power wires of the system.
2-11 Turbo, Remote Start Runtime Extension w/#1 for 2 seconds
When you set this option you can reset the run time of either the remote start or turbo timer. To reset the time you
must hold button 1 for 2.5 seconds while the vehicle is remote started or while the turbo timer is running.
3-1 Parking lights while remote started
This determines the behavior of the parking lights during remote start. At default setting the parking lights turn on
solid until the remote start time runs out, vehicle is taken over with the key or remote start is turned off with the
remote. Setting 2 will flash the parking lights during remote start. Setting 3 turns the parking lights off during
remote start.
3-2 Dome Light Output
This option sets the timing output of the Dome Light wire on CN3.
Option 2: Factory Rearm – On this setting, the system pulses the dome light output while locking/arming the
vehicle. Some vehicles need this to arm the factory alarm. (Dome Light On, Lock (Arm), Dome Light Off)
Option 3: 45 Second Dome Light Output – activates the dome light for 45 seconds after the system is disarmed.
Option 4: Is a combination of options 2 and 3.
3-3 Dome Light Delay
This setting gives the control module the ability to ignore the door trigger for the set amount of time. Without this
option set, if the dome light is still on when the vehicle is armed, the remote will show the door open on the LCD
display. On options 2 and 3, if the door trigger is still active after the set time, the car will chirp and or flash the
parking lights 4 times, and the remote will be paged (if a 2-way remote is used) indicating that the door is open.
Option 4: Door trigger will be ignored until the trigger goes away. Only use this mode when necessary, because if
the door is actually left open, you will not be notified.
18