Table of Contents
Advertisement
5
AUX4 output time
6
AUX5 output time
7
AUX6 output time
8
AUX7 output time
SPECIAL OPTION GROUP #2
Feature
Programmable Output Connector
1
POC #1
2
POC #2
3
POC #3
4
POC #4
5
POC #5
6
POC #6
7
POC #7
8
POC #8
9
POC #9
________________________________________________________________________________________________
CM4 S
O
M
ERIES
PTION
1-1 Unlock before, Lock after, starting
If enabled, this option setting will unlock the vehicle before remote starting to disarm the factory alarm. The vehicle
will then relock after it has been remote started. There is also an option to set the vehicle to lock after remote
starting only.
1-2 Lock /Unlock pulse duration
This option will set the output duration on the lock and unlock wires. The available pulse times are 0.8 sec, 2.5 sec,
0.125 sec. and 3.5 sec.
1-3 Driver's priority unlock
With this option set when you go to unlock/disarm the system it will unlock only the driver's door. You must tap
the unlock/disarm button again within 3 seconds to unlock the passenger doors. The driver's door must be isolated
from the other doors. Some additional installation is required. Please contact technical support for more
information.
1-4 Double pulse unlock
Turning this option on will give the unlock wire two pulses during unlock/disarm. This feature can not be used with
option 1-3, drivers priority unlock.
1-5 Rearm Output
This option determines the behavior of the Orange Rearm wire on CN3. It can be set to pulse after remote start
shutdown and when first arming/locking. It can also be set to pulse during every arm/lock. On some vehicles, if the
lock button is pressed again (1-way remotes) after the system is locked/armed, and the rearm wire pulses while the
factory system is already armed, the factory alarm will be triggered.
1-6 Reservation Lock (Manual Transmission)
This option determines the behavior of locking/arming after setting reservation mode. Setting 2 prevents the vehicle
from locking when setting reservation mode. Setting 3 will provide a 10 second delay after closing the drivers door
to allow the user to open another door. 10 seconds after all the doors are closed, if no other door is opened, the
system will shut the motor off, set reservation, and arm the alarm.
1-7 Unlock/Disarm with Trunk Release
0[Default]
2nd LIGHT
2nd START
2nd IG1
2nd ACC
STATUS
REARM
DISARM
HORN
DOME LIGHT
D
ENU
ESCRIPTIONS
1 ~ 100
1 ~ 100
1 ~ 100
1 ~ 100
Setting Value
1~12
2nd Light[1],
2nd Start[2],
2nd IG1[3],
2nd Acc[4], Status Out[5], Rearm Out[6],
Disarm Out[7],
Horn Out[8], Dome Light[9],
Aux1 Out[10], Aux2 Out[11],
Defrost[12]
16
V
V
V
V
V
V
V
V
V
V
V
V
Applicable To
CM4000
CM4200-DX
CM4300
V
V
V
V
V
V
V
V
V
V
V
V
V
V
V
V
V
V
V
V
V
V
V
Hide quick links:
Advertisement
Chapters
Table of Contents
