Orbit baby Toddler Manual page 52

102
102
Re-Installing the Upholstery
G
1. Re-attach the Adjustable Headrest
by inserting the two tabs into their
corresponding slots and pressing the
hook-and-loop fasteners together
(Photo G). Ensure that all Restraint
Harness buckles are unbuckled, and
that all Upholstery fasteners are pulled
apart. Position the Upholstery within
H
the Toddler Car Seat.
2. Pull each side of the Restraint Harness
through the sides of Center Panel of
the Upholstery (Photo H). Secure the
Center Panel closed.
Note: You MUST make sure that
the Shoulder Straps come through
slots in the Upholstery that are at
the SAME HEIGHT as the slots they
I
come through the Shell.
3. Pull the lap portions of the straps
through the slots at the sides of the
bottom of the Upholstery (Photo I).
Make sure the straps can move freely
through the slots.
4. Pull the Crotch Buckle back through
the buckle opening in the bottom
of the Upholstery, again making
sure to use the same corresponding
Upholstery slot as the slot position
used in the Shell (Photo J).
5. Secure the elastic edges of the
Upholstery by stretching them over the
rim of the carseat (Photo K).
6. Insert the plastic Side Tabs into the
slots by the Side Handles (Photo L).
7. Re-attach the Shoulder Pads and
CHECK that the Shoulder Straps
move freely through the slots and are
not twisted.
8. CHECK that the Restraint Harness is
not twisted and pull on the straps to
make sure the Restraint Harness is
secure.
103
J
K
L
103