Orbit baby Toddler Manual page 27

52
52
Installation with Braces &
P
Lap Style Vehicle Seat Belts
(without Orbit Base)
1. Attach the Braces in a Rear-Facing
position: See pages 41-43.
2. Position the Toddler Car Seat Rear-
Facing on the seat. The child seat
should face the rear of the vehicle.
Q
The FRONT OF VEHICLE arrow on the
Braces should point to the front of your
vehicle.
3. Open the Upholstery Lower Panel
marked by the Blue Dot (Photo P).
4. Open both arms of the blue Belt
Lock-Off Clamp that will be closest
to the center of the vehicle in the fi nal
installation (Photo Q).
R
NOTE: If installing the seat in the
center position, open either Clamp.
Only one clamp is needed for a
secure installation.
5. Position the vehicle seat belt through
the openings in the shell and the open
Blue Lock-Off Clamp as shown and
buckle the seat belt buckle (Photo R).
6. Push down on the carseat and press
down as you pull on the Lap Belt to
tighten it around the child restraint
(Photo S).
7. When tight, push down both arms of the
open Blue Lock-Off Clamp fi rmly until it
locks (Listen for a CLICK) (Photo T).
8. CHECK that the installation is secure by
tugging and pulling the Toddler Car Seat
in near the belt path. The Toddler Car
Seat should not move more than 1 inch
in any direction. If it is loose, push down
on the seat and pull the lap belt tighter.
If it is still loose, remove and re-install it,
beginning at Step 3.
9. Check that the Toddler Car Seat is level
by looking at the Level Indicator on the
Brace (Photo U).
S
T
U
53 53
53 53