Orbit baby Toddler Manual page 22

42
42
Attaching the Braces to the Seat,
M
Rear-Facing Only cont'd
1. Ensure that the Locking Knob on
each Brace is turned to UNLOCKED.
(Photo M). Push in and turn to change
position of locking knob.
2. Position each Brace on the appropriate
side of the carseat for Rear-Facing use:
Make sure that the BLUE strip on the
N
Brace is aligned with the BLUE Rear
Facing strip at the back of the carseat,
and that the FRONT OF VEHICLE arrow
will face the front of your vehicle (Photo
N).
3. Slide both Brace Rods evenly into
the Brace Plug openings in the shell
until the Brace is fully docked and you
cannot see the Brace Rods anymore
(Photos O and P).
O
5. To lock the Brace, fi rst push the Locking
Knob in, then turn (Photo Q). Tug on
the Brace to ensure that it is locked in
position.
NOTE: A small amount of
movement is normal, but the
Brace should not pull off.
6. Install the remaining Brace on the other
side of the Toddler Car Seat by following
steps 1-5.
NOTE: The Toddler Car Seat can
still be used on the Orbit Stroller
when the Braces are installed.
Place the Toddler Car Seat either
Forward- or Rear-Facing.
However, the Braces prevent
the Toddler Car Seat from fully
rotating on the Stroller. To restore
full rotation on the Orbit Stroller,
remove the Braces and store them
in the Cargo Pod.
NOTE: The Toddler Car Seat cannot
dock onto the Orbit Base when the
Braces are attached.
P
Q
43
43