Orbit baby Toddler Manual page 42

82
Strap Loops
Splitter
Plate
82
Adjusting the Restraint Harness to Fit
E
Your Child cont'd
a) Loosen the Restraint Harness by pulling
on the Shoulder Straps while pressing
the Adjuster Strap Lock (Photo E).
b) Open the Rear Access Panel and pull
on the restraint harness from the front to
pull the Splitter Plate up, along with the
strap loops.
F
c) Unhook each shoulder strap loop from
the metal Splitter Plate (Photo F).
d) From the front of the Toddler Car Seat,
pull the shoulder straps out from their
slots and re-thread each shoulder strap
through the correct corresponding
upholstery slots and plastic shell slots
(Photo G).
G
CHECK that each shoulder strap is
threaded into slots at the same height
and that neither shoulder strap is
twisted.
e) Turn to the back of the Toddler Car Seat
again and secure each shoulder strap
loop entirely onto the Splitter Plate as
shown (Photo H).
f) CHECK that the straps are secured by
pulling on the shoulder straps from the
front.
g) CHECK that the upholstery around the
shoulder strap slots do not interfere
with the free movement of the Restraint
Harness.
h) Close the Rear Access Panel and secure
all Upholstery.
2. Adjusting the Shoulder Strap Length
The Adjuster Strap Lock is located under
Lower Upholstery Panel at the very front of
the bottom of the seat where the hanging
Adjuster Strap is attached (Photo I).
a) To loosen the Shoulder Straps, pull on
both sides of the Shoulder Straps while
pressing down on the Adjuster Strap
Lock (Photo E).
b) To tighten the Shoulder Straps, pull on
the Adjuster Strap that hangs from the
front of the carseat (Photo J).
H
I
J
83
83