BMW K 1200 GT Rider's Manual page 118

BMW Motorrad front wheel
7
stand.
116
Mounting front wheel
stand
Placing on center stand
( 83)
z
Loosen adjusting screws 1.
Push two mounting pins 2
far enough apart that front
suspension fits between
them.
Use locating pins 3 to set
front wheel stand to desired
height.
Center front wheel stand
relative to front wheel and
push it against front axle.
Push two mounting pins 2
through triangles of brake
caliper support toward in-
side so that front wheel can
still be rolled through.
With BMW Integral ABS
the ABS sensor ring can
be damaged.
Only push the mounting pin
so far inward that it does not
touch the sensor ring of the
BMW Integral ABS.
Tighten adjusting screws 1.
If the motorcycle is
raised too far at the
front the center stand will lift
clear of the ground and the
motorcycle could topple to
one side.
When raising the motorcycle,
make sure that the center
stand remains on the
ground.
Apply uniform pressure
to push front wheel stand
down and raise motorcycle.