Wiring - Jensen MP6612i Installation And Operation Manual

MP6612i

WIRING

NOTE: The amplifier in this radio
is only designed for use with four
speakers. Never combine (bridge)
outputs for use with two
speakers. Never ground negative
speaker leads to chassis ground.
Failure to wire exactly as shown
may cause electrical damage to
the radio.
NOTE: Only connect speakers
with a nominal impedance of 4
ohms. Speakers with a load
impedance less than 4 ohms
could damage the unit.
DATA BUS
DATA BUS
SAT L SAT R SAT
3.5mm
Audio Only
iPod Video iPod iPod Mini iPod Nano
jLink iPod Cable
(Sold Separately)
5
Ground
Connect to ground terminal
or clean, unpainted part of chassis.
Black
Memory/Battery
Connect to battery or 12 volt power
source that is always live. The radio will
not work if this wire is not connected.
Yellow
FRONT SP
White/Black White Gray/Black Gray
Stripe Stripe
Left Speaker Right Speaker
(Front) (Front)
R (Red)
Rear Line out
Gray L (White)
FrontLine out R (Red)
Black
L (White)
Power Antenna
Connect to power antenna or amplifier.
If not used, tape bare end of wire.
Blue
Accessory/Ignition
Connect to existing radio wire
or radio fuse.
Red
REAR SP
Green/Black Green Purple/Black Purple
Stripe Stripe
Left Speaker Right Speaker
(Rear) (Rear)