Satellite Radio Operation - Jensen MP6612i Installation And Operation Manual

SATELLITE RADIO OPERATION

®
Listeners can subscribe to XM
www.xmradio.com, or by calling (800) 967-2346. Customers should
have their Radio ID ready (see "Displaying the Identification (ID)
Code"). Customers can receive a limited number of free-to-air
channels without activation.
Listeners can subscribe to Sirius
www.sirius.com, or by calling (888) 539-SIRIUS. Customers should
have their Sirius ID ready (Sirius ID is located on the Satellite Radio
Tuner, sold separately). Customers can listen to music samples by
tuning to channel 184.
Accessing Satellite Radio Mode
To switch to Satellite Radio mode, press SRC (7) until "- - SAT - -" appears
on the display. This will not be displayed unless the unit is connected to an
optional XM or Sirius receiver.
MP6612i
/
RADIO
READY
MENU/ENTER-PRESS
1 2
Displaying the Identification (ID) Code
Before you listen to Satellite Radio, you must subscribe to the service using
your radio's identification number. To display the radio ID, press the TUNE/
TRACK |<< button (19) to access channel 000. The screen displays
"RADIO ID" followed by the ID number.
Radio on the Web by visiting
®
Radio on the Web by visiting
TUNE / TRACK
DISP
PTY
CH/CAT
SCAN AS
iPod
3 4 5 6
INT RPT RDM
DN UP
Menu
Selecting a Station
Press the TUNE/TRACK >>| or |<< button (19) to change to another
station.
Preset Stations
Press the BAND button (3) to change between three SAT Radio bands.
Each band stores up to six preset stations. You can store and recall a total
of 18 preset stations.
Store a Station
1. Select a band (if needed), then select a station.
2. Hold a preset button (14) for three seconds. The preset number
appears in the display.
Recall a Station
1. Select a band (if needed).
2. Press a preset button (14) to select the corresponding stored station.
Direct Tuning Mode
To enter a station directly, perform the following steps.
1. Press the AS button (15).
2. Press the MENU button to select "Direct Tune".
3. Turn the rotary encoder to select the third digit of the desired channel
(0-9).
4. Press MENU (22) to enter the number and move to the second position.
5. Turn the rotary encoder again to select the second digit of the desired
channel (0 - 9).
6. Press MENU to enter the second number and move to the first position.
7. Turn the rotary encoder again to select the first digit of the channel you
want to tune to (0 - 2).
8. Press MENU to enter the final number and access the channel.
NOTE: If the channel is unauthorized or invalid, "Unavail" appears on
the LCD and the unit returns to SAT mode.
18
MP6612i