MP6612i TABLE OF CONTENTS Introduction ...1 Installation ...2 Wiring ...5 Front Panel Release ...6 Operation ...7 Tuner Operation ...11 CD Player Operation ...13 MP3/WMA Operation ...14 Satellite Radio Operation ...17 iPod Operation ...19 Bluetooth Operation ...20 Remote Control ...24 Care and Maintenance ...25 Troubleshooting ...26...
MP6612i INTRODUCTION Congratulations on your purchase of the Jensen MP6612i Mobile Receiver. It’s a good idea to read all of the instructions before beginning the installation. We recommend having your Jensen MP6612i installed by a reputable installation shop. Features CD / MP3 / WMA •...
Disconnect Battery Before you begin, always disconnect the battery negative terminal. NOTE: If the MP6612i is to be installed in a car equipped with an on- board drive or navigation computer, do not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost.
MP6612i CAUTION: For proper operation of the CD player, the chassis must be mounted within 20° of horizontal. Place the radio in front of the dashboard opening so the wiring can be brought through the mounting sleeve. Follow the wiring diagram carefully and make certain all connections are secure and insulated with wire nuts or electrical tape.
MP6612i back until they lock, then pull the radio out. If removal keys are inserted at an angle, they will not lock properly and will not release the unit. Sleeve Removal Key Trim Ring Removal Key Technical Assistance If you require assistance, contact Technical Support at 1-800-323-4815...
MP6612i WIRING NOTE: The amplifier in this radio is only designed for use with four speakers. Never combine (bridge) outputs for use with two speakers. Never ground negative speaker leads to chassis ground. Failure to wire exactly as shown may cause electrical damage to DATA BUS the radio.
Position the right side of the panel in place until correctly engaged, then lightly press the left side of the panel until the mechanism locks it into place. MP6612i...
MP6612i OPERATION Power Press the power button (2) to turn the unit on. Press and hold the power button again to turn the unit off. NOTE: LCD panels may take longer to respond when subjected to cold temperatures for an extended period of time. In addition, the visibility of the numbers on the LCD may decrease slightly.
Page 12
Adjust gain to LOW, MID, or HIGH. • Peak Frequency (P. FREQ) Turn the rotary encoder to adjust the Peak Frequency to 400Hz, 800Hz, or 2.4KHz. • BOOST Turn the rotary encoder to select “Flat” or “On” (Bass Boost). MP6612i...
MP6612i Subwoofer (SUB-W) To adjust Subwoofer options, press the MENU button (22) until “SUB-W” appears in the display. Press the TUNE/TRACK >>| or |<< buttons (19) to access the following settings: • SUB-W Turn the rotary encoder to turn the subwoofer feature ON/OFF.
Page 14
MP6612i Reset Button The RESET button (4) is located on the front panel below the rotary encoder. The reset circuitry protects the microprocessor circuitry. Since resetting the unit will erase the time and preset memories, it should only be activated upon initial installation after all wiring is complete, or if there is a malfunction of any of the switches on the unit.
MP6612i TUNER OPERATION The MP6612i allows you to receive channels in U.S.A. or EUROPE mode. See “Frequency Spacing (Area)” on page 9 to learn how to change the tuner options. MP6612i RADIO READY MENU/ENTER-PRESS Select a Band Press the BAND button (3) to change between three FM and two AM (MW) bands.
Page 16
Turn the rotary encoder (22) to move through the list of available categories. After 2 seconds of inactivity, the radio will automatically scan and play the first station it locates in the selected category. NOTE: PTY is a new broadcast technology that may not be extensively available in your area. MP6612i...
MP6612i CD PLAYER OPERATION Insert CD Press the OPEN/EJECT button (1) and the motorized front panel will slide down automatically to display the disc slot. • If a disc is already present, it will be ejected. Remove the ejected disc before proceeding.
(or optional remote control) as described below. Many types of software are available for converting audio files into MP3/WMA formats. Jensen recommends Nero or Roxio Easy CD Creator. Depending on the media type and recording method, some CD-R/ RWs may be incompatible with this unit.
Folder Search, File Search or Folder Select as shown below. The MP6612i player will only recognize three folder levels and does not display folders containing only other folders. In the example above, the unit will display folders 3, 4, 6, and 8, but not 2 and 7 since they do not contain any tracks directly.
Page 20
MP6612i RADIO READY MENU/ENTER-PRESS Pause Press the pause >/|| button (8) to suspend play. Press the pause >/|| button again to resume play. Accessing the ID3 Tag Press the DISP button (18) repeatedly during MP3/WMA play to access the ID3 information manually. The display will show any of the following information that is programmed on the source: Folder Name, File Name, Track Title, Artist Title, Album Name.
Page 21
MP6612i Press MENU to select a file or folder. Repeat above steps as necessary. Press and hold the MENU button to confirm and play the file Character Search Turn the rotary encoder (22) to highlight “Char Search”. Press MENU (22) to confirm. “Char INPUT, A” appears on the screen.
To switch to Satellite Radio mode, press SRC (7) until “- - SAT - -” appears on the display. This will not be displayed unless the unit is connected to an optional XM or Sirius receiver. MP6612i RADIO READY MENU/ENTER-PRESS...
MP6612i Category Tuning Mode To select stations in a specific category, perform the following steps. Press the AS button (15). Turn the rotary encoder to select “Category Tune”. Press the MENU button (22). Turn the rotary encoder to move through the available categories.
OPERATION Accessing iPod Mode Press the SRC button (7) to change to iPod playback mode. iPod playback begins automatically when an iPod is connected. MP6612i RADIO READY MENU/ENTER-PRESS Selecting a Track Press the TUNE/TRACK >>| or |<< button (19) to select a track.
• Before using Bluetooth functions, you must pair your mobile phone to the MP6612i head unit (see “Pairing your Mobile Phone and Head Unit via Bluetooth”). To ensure the best reception for pairing and re- connection, please make sure the phone battery is fully charged before you begin.
NOTE: Not all Bluetooth phones and features are compatible with the MP6612i (i.e HFP and phone book access). Connecting/Disconnecting Your Phone When the phone is out of range of the head unit (approximately 100 feet), it will automatically disconnect. Press and hold the BAND button (3) to manually reconnect the phone when entering the vehicle.
Page 27
Turn the rotary encoder (22) to select the desired Bluetooth volume, from 0- Advanced Audio Distribution Profile (A2DP) The MP6612i allows you to play back audio files from your phone, PDA or personal music player using a Bluetooth connection. Before using an audio player, it may be necessary to enter a PIN code (1234) into the unit.
Page 28
Since there are a number of Bluetooth audio players available on the market, operations with your Bluetooth audio player using this unit vary greatly. Please refer to the instruction manual that came with your Bluetooth audio player as well as this manual while operating your player with the MP6612i. MP6612i...
MP6612i REMOTE CONTROL The remote control will allow you to control many functions of the MP6612i. Operating Range The remote control sensor (20) is located to the right of the PHONE button. The remote control can operate within a distance of 3~5m.
Discs should be kept in their storage cases when not in use. Do not expose discs to direct sunlight, high temperatures or high humidity for long periods. Do not stick paper, tape or CD labels on disc surfaces, as internal damage may occur. MP6612i or NERO burning...
MP6612i TROUBLESHOOTING Problem Cause Does not operate No power to yellow Check connection with test (display does not wire; no power to red light; check vehicle fuse with light) wire test light Inline fuse blown Replace fuse No power to unit...
Limited Warranty CD or Multimedia Radios/Headunits Audiovox Electronics Corporation (“the Company”) is committed to quality and customer service, and are pleased to offer you this Warranty. Please read it thoroughly and contact the Company at 1-800- 323-4815 with any questions. Who is covered? The Company extends this warranty to the original retail purchaser of products purchased through an authorized Audiovox retailer in the U.S.A., Puerto Rico or...
Need help?
Do you have a question about the MP6612i and is the answer not in the manual?
Questions and answers