Training Overview - Xerox Integrated Fiery Color Server Quick Start Manual

INTRODUCTION

Training overview

1-2
This course is designed for both the Xerox Analyst and the Service
Representative.

For Xerox Analysts, Module 2: Configuration of the Integrated Fiery
Color Server is required and Module 3: Servicing the Integrated
Fiery Network Controller is optional.

If you are a Xerox Service Representative, Module 2: Configuration
of the Integrated Fiery Color Server is optional and Module 3:
Servicing the Integrated Fiery Color Server is required.
Course Prerequisites
The Xerox Service Representative training prerequisites for this
course include the following:
These training prerequisites are available via Xerox eLearning and
can be located by searching the short code for each prerequisite
(i.e., the short code for Color Basic is C10500).
In addition, The Xerox Service Representative is required to have
the following hardware and software:

If you do not meet all of these prerequisites, call your instructor over
to discuss a recovery plan. This may include evening or post-
school work to complete all of the requirements. In rare cases it
might mean that you should not take the present course until some
later date.

Color Basic (C10500)

Network Continuum Basic (C7166)

Introduction to Digital (C9250)

Laser Safety Training Program (772P20441)

PWS/PSS Skills Knowledge

Ishihara Color Test (C1124)

A Personal Work Station (PWS) configured with Xerox
Golden Image

Internet Explorer v. 6.0

Minimum 500 MB free space on your C: drive

Laptop with a Network Interface Card (NIC) installed
8/09
Integrated Fiery Color Server
CONFIGURATION TRAINING GUIDE