Panasonic WJ-HD616K Operating Instructions Manual page 54

• To delete the set detection area, take the following
procedures.
1. Move the cursor onto the [Delete area] button
on the search filter window, and then press the
[SET] button.
2. Move the cursor onto the [Area] button of any
of the detection area (A - D), and then press
the [SET] button.
4. Set the detection sensitivity of each detection
area.
Move the cursor onto "Sensitivity" of the detection
area to be set, and then rotate the jog dial (inside)
to select the detection sensitivity from the follow-
ing.
Off: Does not detect motion in the selected area.
Low: Low sensitivity
Mid: Standard sensitivity
High: High sensitivity
5. Set the mask duration.
When the mask duration is set, any motion will not
be detected for the set duration after a motion
detection. Use the mask duration when it takes
time to detect motion or when motion is detected
frequently.
Rotate the jog dial (inside) to select the detection
sensitivity from the following.
1s, 1min, 1h, 24h
54
Step 5
After specifying the search conditions (filters), press
the [SET] button after moving the cursor onto the [B]
button.
→ Data matched the search conditions (filters) will be
displayed on the VMD search list window.
Step 6
Select time and date of recorded data from the list to
play. To select a recorded data in which motion was
detected, rotate the jog dial (inside).
Note:
• When the shuttle ring (outside) is rotated, the pre-
vious/next page of the list will be displayed.