Foxconn 761GXK8MC User Manual page 24

1394 Connectors: F_1394_1,F_1394_2
(Optional)
The 1394 expansion cable can be connected
to either the front (provided that the front panel
of your chassis is equipped with the appropri-
ate interface) or real panel of the chassis.
Serial ATA Connectors: Serial ATA -1,
Serial ATA
-2
The Serial ATA header is used to connect the
Serial ATA device to the motherboard.
These connectors support the thin Serial ATA
cables for primary internal storage devices.
The current Serial ATA interface allows up to
150MB/s data transfer rate.
S/PDIF Out Connector: SPDIF_OUT
The S/PDIF out connector is capable of pro-
viding digital audio to external speakers or
compressed AC3 data to an external Dolby
digital decoder.
Note:
The empty pin of SPDIF cable should be
aligned to empty pin of SPDIF out connector
Audio Interface: F_AUDIO
The audio interface provides two kinds of
audio output choices: the Front Audio, the
Rear Audio. Their priority is sequenced from
high to low (Front Audio to Rear Audio). If head-
phones are plugged into the front panel of
the chassis (using the Front Audio), then the
Line-out (Rear Audio) on the rear panel will
not work. If you do not want to use the Front
Audio, pin 5 and 6, pin 9 and 10 must be
short, and then the signal will be sent to the
rear audio port.
Chapter 2 Installation Instructions
GND
12V
TPB -
GND
TPA -
1
F_1394 _1/2
GND
1
TX+
TX-
GND
RX-
RX+
GND
SATA_1/SATA_2
1
5V
Empty
DATA
GND
SPDIF_OUT
1 2
MIC
MIC_PW R
AUD_OUT_R
NC
AUD_OUT_L
9
10
F_AU DIO
Empty
12V
TPB +
GND
TPA +
MIC_GND
+5VAC
AUT_RET_R
EMPTY
AUT_RET_L
17