Preparation; Opening The Server - Fujitsu Primergy RX100 S3 Options Manual

4

Preparation

V
CAUTION!
Observe the safety instructions in the
et seqq. .
4.1

Opening the server

Ê Terminate all applications and shut down the server correctly.
Ê If your operating system has not switched off the server, press the on/off
button.
Ê Pull all power connectors out of the power outlets.
Ê Disconnect all cables on the rear of the server.
2
Figure 2: Pulling the server out of the rack
Ê Loosen the two knurled screws (1) and pull the server as far as possible out
of the rack.
Ê Press the locking spring (1) on both sides and carefully pull the server
outward.
Ê Pull the server out of the rails and place it on a table, for example.
U41617-J-Z156-1-76
chapter "Safety notes" on page 11
Options Guide
1
17