Connecting A Ups To The Dns-343 - D-Link ShareCenter DNS-343 User Manual

To add an Uninterrupted Power Supply (UPS), carry out the following steps:
• Turn off the DNS-343 if it is not already powered down.
• Connect the UPS to the USB port on the back of the DNS-343.
• Connect the power of the DNS-343 to the UPS.
• Turn on the UPS.
• Turn on the DNS-343.
• Verify the UPS is properly connected and powered on by going to the Device Information window.
UPS Info:
The UPS Information screen displays information
about the UPS Manufacturer and the Product name.
Battery Charge:
Battery Charge indicates the battery power state of the
UPS (not all UPS' support this function).
Status:
The Status field will display one of the three messages
below:
1. OL: This indicates that the UPS is online.
2. OB: This indicates that the UPS is running on
battery, meaning that there has been a power
failure. The DNS-343 is consuming the battery
power of the UPS and any data should be saved
immediately to prevent any work being lost.
3. LB: This indicates that the UPS has low battery
power.
When a UPS (Uninterrupted Power Supply) USB management connection is connected to the DNS-343, the Status screen hides the printer information and displays
information about the UPS connected. The screenshot on the right-hand side shows the Status screen when a UPS is attached to the DNS-343. The following parameters
are displayed in the UPS Info section:
D-Link DNS-343 User Manual

Connecting a UPS to the DNS-343

61