Serial Communication - Datamax APEX 2 User Manual

3.3 Serial Communication


The RS232C Interface signals for the APEX 2 Series printers are terminated on a 6 PIN RJ
type data connector located on the side of the printer.

Six connections are provided from the Serial Interface to the host computer.
below, lists the Serial Interface signals and pin outs on the RJ connector. The connector
pin locations are shown in Figure 11.

A minimum of two pin connections are required for operation, RXD – pin 3 and Common –
pin 1.

Dip Switch #1 and #2 must be in the <OFF> position to activate the serial communication
interface
Note: The communication parameters: Baud rate, Data Bit and Parity settings must match those of
the host device. Dip switch #1 must be in the OFF position.
FIGURE 11: RJ DATA CONNECTOR
Table 3 – APEX 2 Serial RS232C Interface signals
12
Table 3,