Synchronizing The Optional Wireless Keyboard Or Mouse - HP Compaq 6000 Reference Manual

Synchronizing the Optional Wireless Keyboard or
Mouse
The optional wireless keyboard and mouse are easy to set up. Just remove the battery tabs on both the
keyboard and the mouse. Also, make sure the Power switch on the bottom of the mouse is in the On
position (the keyboard does not have a Power switch). Then, turn on the computer. If you have trouble
using the keyboard and mouse, manually synchronize them as described below.
NOTE: For better mouse battery life and performance, avoid using your mouse on a dark or high-
gloss surface, and turn mouse power off when not in use.
The wireless keyboard and mouse are pre-synchronized to work with your computer. The keyboard and
mouse should work immediately after you first pull the battery tabs to activate the preinstalled batteries,
and then turn on the mouse.
You may need to manually synchronize the wireless keyboard or mouse if they are not functioning. To
synchronize them:
1.
Make sure the keyboard and mouse are next to the computer, within 30 cm (1 foot) and away
from interference from other devices.
2.
Turn on the computer.
3. Insert the wireless receiver into a USB port on the computer. HP recommends connecting the
receiver to the USB port located between the power connector and the PS/2 keyboard connector
on the rear I/O panel.
Figure 2-33
4.
Make sure the Power switch on the bottom of the mouse is in the On position (1).
ENWW
Installing the Wireless Receiver

Synchronizing the Optional Wireless Keyboard or Mouse

37