Removing The Port Cover - HP Compaq 6000 Reference Manual

6.
Insert the hooks on the port cover into the slots on the rear I/O panel and slide the port cover to
the left until it stops.
NOTE:
Figure 2-5
7. Replace the center access panel (see
power cord into an electrical outlet.
8. To lock the port cover in place and secure the cable connections, install an optional security lock
in the slot on the center access panel. See

Removing the Port Cover

NOTE:
The port cover is an optional security device. It prevents access to the rear ports and secures
the cable connections when locked in place.
1.
Remove/disengage any security devices that prohibit opening the computer.
2. Turn off the computer and unplug the power cord from the power outlet.
3.
Place the computer face down on a soft flat surface. HP recommends that you set down a blanket,
towel, or other soft cloth to protect the screen surface from scratches or other damage.
4.
Remove the center access panel (see
ENWW
Ensure that all peripheral device cables are routed through the slots in the port cover.
Installing the Port Cover
Replacing the Center Access Panel on page
Installing a Security Lock on page
Removing the Center Access Panel on page
13) and plug the
33.
12).
Removing the Port Cover
15