Table of contents Table of contents General information........................................5 1.1 Symbols and signal words....................................5 Safety instructions.......................................... 6 Scope of delivery..........................................7 Assembly.............................................. 8 Protecting the environment....................................12 MPS-150 E-Drum Set...
Our products and documentation are subject to a process of continuous development. They are therefore subject to change. Please refer to the latest version of the documentation, which is ready for download under www.thomann.de. 1.1 Symbols and signal words In this section you will find an overview of the meaning of symbols and signal words that are used in this document.
Safety instructions Safety instructions DANGER! Risk of injury and choking hazard for children! Children can suffocate on packaging material and small parts. Children can injure themselves when handling the device. Never allow chil‐ dren to play with the packaging material and the device. Always store packaging material out of the reach of babies and small children. Always dispose of packaging material properly when it is not in use.
Scope of delivery Scope of delivery Before you assemble your e-drum set, check the following list to ensure the delivery is complete. E-Drum Set Millenium MPS-150 E-Drum Module Millenium MPS-150 Rack with pad brackets Hi-hat controller Bass drum pedal (complete)
Assembly Assembly Overview Loosen the screws of the clamps before sticking the tubes together. Mount the various elements in the specified sequence. The positions of the pads, cymbals, etc. are shown in the illustration below. MPS-150 E-Drum Set...
Page 9
Assembly Assembling the rack CAUTION! Risk of cuts to the hands from sharp edges during assembly! Tools, screws and components can have sharp edges that can cause cuts during assembly. Pay attention to sharp edges when assembling and screwing the individual parts. Wear protective gloves if necessary. &...
Page 10
Assembly Mounting pads on the rack Attach the supplied L-pieces to the pads. Tighten the wing nuts on the pads by hand first. Then slide the plastic ends of the L-pieces up to the stop into the designated clamps on the rack. Align the pads on the rack to meet your needs, then tighten the wing nuts of the pad brackets and the bolts of the pad clamps on the rack evenly.
Page 11
Assembly Setting up the bass drum pedal Snap the two metal rods into the holes provided on the frame of the bass drum pedal. Place the beater into the hole provided on the rotary head of the pedal and tighten the clamp with the drum key. Bass drum and hi-hat Place the bass drum pad centred under the rack.
When disposing of the device, comply with the rules and regulations that apply in your country. You can also return your old device to Thomann GmbH at no charge.