Control 4 CCZ-T1-W Installation Manual page 9

• New construction, Control4 recommmends these options:
• Install a common wire.
• Use a Remote Temperature Sensor in the wall where the Thermostat is located. Run a wire to
the furnace, and then install the Thermostat next to the furnace.
• Retrofits, the best solution is to install the Thermostat using an existing common wire. If the box
does not have a common wire, you can:
• Run a wire from the furnace to the Thermostat location.
• Use Power Stealing (see Step 14 in "Installation Instructions").
• Install a Remote Temperature Sensor in the wall where the Thermostat is located. Run a wire to
the furnace, and install the Thermostat next to the furnace. See "Remote Temperature
Sensor."
• Use a separate 24VAC transformer to power the Thermostat.
Supported System Types
This table lists the items that the Thermostat replaces.
Description
Heat pump (no aux. or emergency heat)
Heat pump (with aux. or emergency heat)
Standard heating and cooling system
Two-stage heat and two-stage cooled
Standard heat-only systems
Millivolt heat-only systems - floor or wall furnaces
Standard central air conditioning
Gas or oil heat
Electric furnace
Hydronic (hot water) - zone heat - 2 wires
Hydronic (hot water) - zone heat - 3 wires
CCZ-T1-W
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
5