Kodak Prosper S10 Operator's Manual page 36

Chapter 3. Printer Maintenance
Filter Replacement
Figure 29 PIC box dry shutdown valve filter
Captive
screw
Kodak Prosper
36 S10 Printer
3. Get access to the top of the PIC box (Figure 29).
a. Loosen the six captive screws (four on the back and two on the
front).
b. Remove the cosmetic cover.
4. Replace the damaged dry shutdown valve filter (Figure 29).
a. Turn the damaged dry shutdown valve filter counterclockwise to
remove it.
b. Turn the new dry shutdown valve filter clockwise to install it.
5. Close the top of the PIC box (Figure 29).
a. Replace the cosmetic cover.
b. Tighten the six captive screws (four on the back and two on the
front).
Cosmetic
cover
Dry shutdown
valve filter
WARNING
Pinch hazard can cause damage to hands and fingers at these places:
• Between two buckets
• Between outer most bucket and bucket frame on the left side
• Between inner most bucket and bucket frame on the right side
6. If necessary, put the carriage rail back to its initial position (Figure 30).
a. Push in the carriage rail.
b. Rotate the lock handles clockwise.
7. Do "Turn On the Print Station" on page 15.
.
Figure 30 Carriage rail
Lock handles
PIC box
Carriage rail