Power Procedures
Power switch
Chapter 2.
This chapter gives common operator procedures for the S10 Printer:
•
Turn the power on and off
•
Correct Print Defects—See Kodak Prosper S10 Imprinting System
Basic Operations Guide
•
Replace the fluid containers—See "Fluid Container
Replacement" on page 17
•
Clean the PIC box—See "Clean the PIC Box" on page 23
This section gives the procedures to turn the print station on and off.
Turn On the Print Station
1. If necessary, turn the power on for the print tower(s).
a. If the printing system has a transformer, turn the main switch on.
b. Turn the main switch on at the print tower(s) infeed power
cabinet.
NOTE
The power-on cycle is several minutes long.
2. Turn the power switch on at the print station (Figure 2).
3. Select
to reset system controller and/or jetting module
Ack Error
errors.
Figure 2
Power switch
Printer Operation
Operator's Guide
15