Service Management Tasks
This section discusses basic procedures of the following service management tasks:
•
•
•
To change an MDA type already provisioned for a specific slot/card, first you must shut down the
slot/MDA/port configuration and then delete the MDA from the configuration. Modify and delete
operations can be performed only on the MDAs that are not auto equipped or auto provisioned.
Use the following CLI syntax to modify an MDA:
CLI Syntax: config> port port-id
CLI Syntax: config> card slot-number
7210 SAS E Interface Configuration Guide
Modifying a Card Type on page 56
Deleting a Card on page 57
Deleting Port Parameters on page 57
shutdown
shutdown
[no] mda mda-number
[no] mda-type mda-type
shutdown
Interface Configuration
Page 55