Radio/Clock Functions - Dab+/Fm Version; Setting The Clock; Radio Operation; Tuning The Radio - iCentral M200 User Manual

RADIO/CLOCK FUNCTIONS – DAB+/FM VERSION

SETTING THE CLOCK

There is no need to set the clock. The first time the power button
is pressed, the tuner will automatically scan for available digital
radio stations and synchronize the time and date.
The time is normally displayed when the radio is turned off
however the time may be viewed while the radio is on by
repeatedly pressing the INFO button until the time and date is
displayed.

RADIO OPERATION

 Press the POWER button at the master station to turn the radio on or off throughout the system.
(Time is displayed when radio is turned off)
 Ensure the green TUNER indicator is illuminated at the master station (Press AUX then 3 if it is not)
 Press the MUS button at any station to enable Music mode for that station.
(The red light will be on when Music mode is enabled)
 The radio volume can be adjusted individually at each station using the VOLUME buttons.
 Press the MUS button again to exit Music mode.

TUNING THE RADIO

 Press the POWER button at the master station to turn the radio on.
 (The tuner may automatically scan for available DAB radio stations if required by the tuner)
 Press the DAB/FM button to select DAB or FM.
 For DAB stations, use the BAND+ and BAND– buttons to cycle through the available radio stations and press
ENTER to select the station you want to listen to.
 For FM stations, use the BAND+ and BAND– buttons to tune the desired radio frequency.
 (Press the BAND+/– buttons repeatedly to single step or press and hold to quickly scan)
 If radio presets have been stored, you can select programmed radio stations by pressing buttons
M1 to M4 or press the SHIFT button followed by M5 to M8.

STORING RADIO PRESETS

 Eight DAB and eight FM radio presets may be stored.
 Press the POWER button at the master station to turn the radio on.
 Tune to the desired radio station as outlined above.
 Press and hold buttons M1 to M4 to store radio presets 1 to 4.
 To store radio presets 5 to 8, press the SHIFT button and then press and hold buttons M5 to M8.

USING THE WAKE-UP ALARM

 Press the ALARM button to indicate the alarm status (On or Off)
 Press the BAND+ or BAND– button to change the status and then press ENTER
 Press the BAND+ or BAND– button to change the alarm type (Radio or Beep) and then press ENTER
 Use the BAND+ button to adjust the alarm time Hours (take note of am/pm)
 Press the BAND– button to select the alarm time Minutes and use the BAND+ button to adjust
 Press Enter to display the current alarm status
 Press Enter again to exit the alarm setup
NOTE: If the alarm type is Radio, the radio will turn on at the designated alarm time using the last radio station to be used.

OTHER FUNCTIONS

 Pressing the AUTO button with DAB radio selected, forces the tuner to scan for all available DAB stations.
 Pressing the AUTO button with FM radio selected scans for the next FM station
 Pressing the INFO button displays additional information including Radio Text, Signal Strength, Time & Date etc.
Clock and radio setup applies only to
systems fitted with a master station.
Master Station clock and radio display
10
7