Remote Power On/Off Switch Connector: JRMS1
Connect to a 2-pin push button switch. When OFF, pressing the but-
ton can turn the system on. When ON, pressing the button once will make the
system enter the sleep/suspend state. If the button is pressed for more than
four seconds, the system will be turned off. To change the setup, go to the
BIOS Power Management Setup.
TOP TECH III: JTECH1
This is used to detect the AGP card temperature. The 2-pin connector
can be connected to a 20cm thermistor to monitor the AGP thermal status.
20cm length
Thermistor
JRMS1
2-21
Hardware Setup
JTECH1