Sg Pattern - Pioneer PRO-R06U Training Manual

3. SG PATTERN

No. Function/Display
1 COLOR BAR1
2 COLOR BAR2
3 RAMP1
4 RAMP2
5 RAMP3
6 RAMP4
7 RAMP5
8 RASTER1
9 RASTER2
10 RASTER3
11 RASTER4
12 RASTER5
13 RASTER6
14 RASTER7
15 RASTER8
16 10STEP1
17 10STEP2
18 10STEP3
19 10STEP4
20 10STEP5
Notes when using SG MODE/SG PATTERN
During factory mode, choose the correct route when changing.
Basically, during VDEC SG output, make sure to connect SG output's Y or G to the
AVI input terminal of VDEC.
During SG MODE, turn off the blanking 50IRE setup function.
During VDEC SG output, set the YC seperation setting to NTSC.
It is possible to use ANALOG OUT MODE together during DIGITAL OUT MODE.
The Main VDEC can output digital color difference, in which colors will appear. But the route to
VDEC input cannot be analysed therefore care should be taken when using.
Depending on the situation, please use the proper analog/digital output.
The SG MODE outputs color difference and RGB only. Therefore, in the case of CVBS, only
the Y input is used resulting in no color. This is not a damage result nor error.
The SG MODE's ANA AD RGB (route to input 525i to AD by RGB) as a set's route, the setting
does not exist. For this account the latter part from MVDEC does not have set values, resulting
in having funny colors in colorbar, the brightness changes after switching, etc.
This is not a damage result nor error.
Depending on MVDEC's part version, ANA_MVDEC_YCBCR may not display colors.
Figure. SG PATTERN
SG Pattern Brightness IRE Level/Color
Colorbar 75%
Colorbar 100%
Ramp 100% white
Ramp 100% Yellow
Ramp 75% Green
Ramp 75% Red
Ramp 75% Blue
Raster 100% White
Raster 75% Yellow
Raster 75% Cyanide
Raster 75% Green
Raster 75% Magenta
Raster 75% Red
Raster 75% Blue
Raster -% Black
10STEP 100% white
10STEP 100% Yellow
10STEP 75% Green
10STEP 75% Red
10STEP 75% Blue
34